User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
47
Verifying the Connection
Step 2: Attach the Dynamic Bracket to the Wireless Bridge
11 Verifying the Connection
Once you have completed the hardware installation and network configuration for both
Wireless Bridges, verify the connection and signal integrity between the bridge pair using
the following procedure:
1. Access the root bridge Web interface by entering its IP address into a Web browser
on a computer connected to the same switch that the root bridge is connected to.
2. On the Status > Wireless page, check to make sure the non-root bridge is listed under
the Connected Device section.
Figure 38. Viewing connected device from the Web interface
3. On the Status > Wireless page, click the SpeedFlex icon to launch the SpeedFlex
Wireless Performance Test.
4. Click Start to begin testing
5. Once the test is completed, the following result page is displayed.