User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
44
Mounting and Connecting the External Antennas (Optional)
Step 2: Attach the Dynamic Bracket to the Wireless Bridge
Figure 36. Insert thumb screws into the upper mounting holes
7. Finger tighten the thumb screws.
8. Adjust the Wireless Bridge to your desired orientation.
NOTE: If you have not yet determined the optimal orientation for your Wireless Bridge,
refer to “
Determine the Optimal Mounting Location and Orientation” on page 25 for
orientation guidelines.
9. Using a 10mm ratchet wrench, tighten the hex bolts to fix the Wireless Bridge’s
orientation. Screw torque value must be 4kg-5kg.
You have completed mounting the root bridge. Perform the same procedure for mounting
the non-root bridge.
9 Mounting and Connecting the External
Antennas (Optional)
If you want to extend the range of your wireless network, you can connect two N-type
external antennas to the standard N-type female connectors on the Wireless Bridge.
WARNING: Only trained and qualified personnel should be allowed to install, replace,
or service this equipment.