User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
42
Mounting the Wireless Bridge
Step 2: Attach the Dynamic Bracket to the Wireless Bridge
8 Mounting the Wireless Bridge
To mount the Wireless Bridge, you will need to join the two mounting brackets that you
attached earlier to the device and the mounting surface. For this procedure, you will need
the following items:
■ Hex bolts
■ Thumb screws
■ 10mm ratchet wrench
NOTE: Figures in this section show mounting on a vertical pole. Procedures for mounting
on a flat surface are similar.
To join the two mounting brackets together:
1. Join the two brackets as shown in Figure 34
. Make sure that:
• The dynamic bracket (attached to the Wireless Bridge) encloses the static bracket
(attached to the mounting surface).
• (For mounting on a vertical pole) The side of the Wireless Bridge with the antenna
connectors is at the top, especially if you are planning to install external antennas.
Figure 34. Joining the two brackets in a vertical pole installation
2. Align the mounting holes on the dynamic bracket with the mounting holes on the static
bracket.
3. Place a split lock washer, and then a flat washer onto a hex bolt. Then insert the hex
bolt into one of the lower mounting holes.