User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
40
Attaching the Mounting Brackets
Step 2: Attach the Dynamic Bracket to the Wireless Bridge
Step 2: Attach the Dynamic Bracket to the Wireless
Bridge
1. Place the dynamic bracket onto the flat side of the Wireless Bridge so that the four
screw holes on the bracket align with the four screw holes on the Wireless Bridge. Make
sure that the shorter end of the mounting bracket is on the same side as the antenna
connector.
2. Insert four machine screws (supplied with mounting kit) into the screw holes on the
bracket.
Figure 32. Insert four machines screws into the screw holes