User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
39
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
2. Use the clamps to attach the bracket to the pole.
Figure 30. Use the clamps to attach the bracket to the pole
3. Using a 10mm flathead screwdriver, tighten the clamp locks to secure the bracket to
the pole. Screw torque value must be 4kg-5kg.
Figure 31. Tighten the clamp locks to secure the bracket
4. Continue to “Step 2: Attach the Dynamic Bracket to the Wireless Bridge”.