User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
38
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
9. Using a 10mm open-end wrench, tighten the nuts to secure the bracket to the
mounting surface. Screw torque value must be 4kg-5kg. As you tighten the nuts, the
metal cones that are built into the wall anchors will expand and lock the wall anchors
into place.
10. Continue to “
Step 2: Attach the Dynamic Bracket to the Wireless Bridge”.
Attaching the Bracket to a Pole
The Wireless Bridge can be mounted vertically on a 30mm to 60mm (1.18 in. to 2.36 in.)
pole.
1. Insert the open end of the steel clamps into the two tabs on the bracket.
Figure 29. Insert the steel clamps into the two tabs on the bracket