User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
36
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
1. Place the static bracket at the exact location on the mounting surface where you want
to mount it.
2. Use the static bracket as a template to mark the locations of the mounting holes on
the two mounting tabs.
Figure 25. Mark the locations of the mounting holes
3. Remove the static bracket from the mounting surface.
4. Drill an 8mm-diameter hole with a depth of 36mm-38mm into each of the markings
that you made on the mounting surface.
5. Insert a wall anchor (with the unthreaded part first) into each of the holes that you
drilled.
6. Place a metal cone on each wall anchor, and then place a flat washer on top of the
metal cone.
Figure 26. Insert a wall anchor into each hole that you drilled, and then place a metal
cone and a flat washer on top