User's Manual

35
Attaching the Mounting Brackets
What You Will Need
7 Attaching the Mounting Brackets
What You Will Need
To complete this procedure, you will need the following items:
■ Static bracket
■ Dynamic bracket
■ Wall anchors
■ Flat washers
■ Hex nuts
■ 10mm ratchet wrench
If you are mounting the Wireless Bridge on a flat surface, you will also need an electric drill
with an 8mm drill bit.
If you are mounting the Wireless Bridge on a pipe or pole, you will also need the following:
■ A 30mm to 60 mm (1.18 in. to 2.36 in.) pipe or pole
■ Steel clamp
■ 10mm flathead screwdriver
Step 1: Attach the Static Bracket to the Mounting
Surface
The procedure for attaching the bracket to the mounting surface depends on whether you
are mounting the Wireless Bridge to a flat surface or a pole.
■ Attaching the Bracket to a Flat Surface
■ Attaching the Bracket to a Pole
Attaching the Bracket to a Flat Surface
WARNING: Ruckus Wireless strongly recommends that you wear eye protection before
drilling holes on the mounting surface.
NOTE: The wall anchors that are supplied with the Wireless Bridge are for mounting on
solid masonry walls only. If you are mounting the Wireless Bridge on other materials (for
example, drywall, wood, or hollow cinder block), you will need the appropriate types of
wall anchors. Check your local hardware store for options.