User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
33
Deploying the Wireless Bridge
Step 3: Connect the Wireless Bridge to the Network
Figure 23. Fasten the bottom cover using three machine screws
Step 3: Connect the Wireless Bridge to the Network
In this step, you will connect the Wireless Bridge from its mounting location to the
network. Follow the steps below for a typical installation that uses both PoE and DC
power as power sources. Figure 24
shows an example of the connections required for a
typical installation that uses both PoE and DC power.