User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
32
Deploying the Wireless Bridge
Step 2: Install the Back Panel Cover
WARNING: Do not apply power to the Wireless Bridge at this point. You should connect
the Wireless Bridge to a power source only after you finish connecting all other
components in “
Step 3: Connect the Wireless Bridge to the Network” on page 33.
Figure 22. Install the white P-clip cable clamp
CAUTION: If you are not connecting the DC cable to the DC terminal block, make sure
you cover the right cable groove with the supplied sealing plug.
You have completed setting up the DC power connection.
Step 2: Install the Back Panel Cover
Place the bottom cover of the Wireless Bridge onto the bottom section, and then fasten
it using the three machine screws that are supplied with the Wireless Bridge.
CAUTION: Before installing the bottom cover, verify that the perimeter rubber gasket on
the underside of the cover is clear of debris.
P-clip Cable
Clamp
Sealing
Strip