User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
29
Deploying the Wireless Bridge
Step 1: Complete the Power Connections
Figure 17. Connect the Ethernet cables and power adapter to the PoE injector
7. Take out one of the 20mm x 30mm sealing strips from the accessories bag.
8. Remove the adhesive backing from the sealing strip.
9. Wrap the sealing strip around the Ethernet cable, about 40mm from the Ethernet
connector.
Figure 18. Wrap the sealing strip around the Ethernet cable, 40mm from the Ethernet
connector
10. Place the Ethernet cable in the cavity on the enclosure, and then press it into position.
Make sure the sealing strip protrudes beyond the entry and exit points.
11. Wrap the white P-clip cable clamp around the Ethernet cable, and then fasten it to the
Wireless Bridge chassis using one of the short machine screws supplied.
To N etworkTo Outdoor Bridge
To AC Power Source
40mm
Sealing strip