User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
20
Preparing the Wireless Bridge Pair for Installation
Configure the Non-Root Bridge (Optional)
NOTE: This process may take several minutes. Do not unplug the ZoneFlex 7731 while
it is updating its IP address.
Configure the Non-Root Bridge (Optional)
If you want to change the IP address or other wireless settings for the non-root bridge,
repeat steps 1-4. If not, you only need to repeat step 1 to provide power to the non-root
bridge, then proceed to Step 5: Test the Link Between the Bridges
.
Step 5: Test the Link Between the Bridges
The SpeedFlex utility lets you test the data transfer speeds between the two bridge units.
Click the SpeedFlex icon on the home page (Status > Wireless) to begin testing.