User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
19
Preparing the Wireless Bridge Pair for Installation
Configure the Root Bridge
Step 4: Change the IP Address (Optional)
The Ruckus Wireless ZoneFlex 7731 Wireless Bridge pair comes with IP addresses pre-
assigned. If you want to change the IP address of either or both of the pair, you can manually
assign a static IP address on the Configuration > Bridge page in the Web interface, or
allow dynamic IP assignment using a DHCP server.
To assign a static IP address, select the Static IP radio button after “Connection Type,”
and enter the desired address and subnet mask as shown in Figure 12
.
Figure 12. Changing the IP address
Click Update Settings to confirm the changes.
You will need to re-enter the new IP address in your browser and login again to continue
editing configuration options. The non-root bridge will automatically detect the new IP
address of the root bridge and attempt to associate with it.