User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
18
Preparing the Wireless Bridge Pair for Installation
Configure the Root Bridge
Figure 11. Ruckus ZoneFlex 7731 Wireless Bridge Status>Wireless page
8. Continue to “
Step 3: Ensure Network and Wireless Settings are Correct”.
Step 3: Ensure Network and Wireless Settings are Correct
On the Configuration > Wireless page, ensure that the following settings are correct:
■ Channel: SmartSelect
■ Country Code: If your location is other than the United States, change the country
code to the correct location.
■ Wireless Availability: Enabled
■ Broadcast SSID: Disabled
NOTE:: Ruckus Wireless recommends leaving these settings at their default values until
installation of both bridge units is complete. Note that any changes made to the root
bridge settings must also be performed on the non-root bridge.