User's Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Preparing the Wireless Bridge Pair for Installation
- What You Will Need
- Configure the Root Bridge
- Configure the Non-Root Bridge (Optional)
- 5 Physical Installation
- 6 Deploying the Wireless Bridge
- 7 Attaching the Mounting Brackets
- 8 Mounting the Wireless Bridge
- 9 Mounting and Connecting the External Antennas (Optional)
- 10 Aiming the Bridge Pair
- 11 Verifying the Connection
- 12 What to Do Next
16
Preparing the Wireless Bridge Pair for Installation
Configure the Root Bridge
Figure 9. Sample configuration in the Internet Protocol (TCP/IP) Properties dialog box
Step 3: Connect the Wireless Bridge to the Admin
Computer
If you have not already done so, connect the admin computer to the ZoneFlex 7731 using
an Ethernet cable, or two Ethernet cables and a PoE injector if you are using Power over
Ethernet (see “
Connect the Ethernet cables and power adapter to the PoE injector” on
page 13
).
Step 4: Log In to the Web Interface
1. Open a Web browser window from the admin computer.
2. In the address or location bar, type the following address:
Root Bridge: http://192.168.2.1
Non-Root Bridge: http:/192.168.2.254
3. Press <Enter> on the keyboard to connect to the Wireless Bridge’s Web interface. A
security alert message appears.
4. Click Yes or OK (depending on the browser) to continue. The Wireless Bridge’s login
page appears.