User Manual

42
Physical Installation
Deploying the Wireless Bridge
Figure 35. Connect the ground wire to the V- terminal and the +12V DC wire to the V+
terminal
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal
4. Using a 3mm Phillips screw, tighten the wiring terminal screws. Screw torque value must
be 20.5 mN-m ± 2 mN-m.
5. T
ake out one of the 20mm x 30mm sealing strips from the accessories bag.
6. Remove the
adhesive backing from the sealing strip.
7. W
rap the sealing strip around the DC cable, about 60mm from the DC terminal block.
Figure 36. Wrap the sealing strip around the DC cable, 60m
m from the DC terminal
block
60mm
Sealing strip
8. Connect the DC terminal block to the 12V DC port on the Wireless Bridge.
9. Place
the DC cable into the right cable groove on the enclosure, and then press it into
position. Make sure the sealing strip protrudes beyond the entry and exit points.
10. W
rap the white P-clip cable clamp around the DC cable, and then fasten it to the
Wireless Bridge chassis using one of the short machine screws supplied with the
Wireless Bridge.