User Manual

Physical Installation

Deploying the Wireless Bridge

Figure 34. Install the white P-clip clamp

Sealing

strip

P-clip cable

clamp

You have completed setting up the PoE power connection.

Use DC Power

To use DC to power the Wireless Bridge, you need to connect a DC cable (not supplied

with the Wireless Bridge) to the DC terminal block.

1. T

ake out the DC terminal block from the small plastic bag that contains the bottom

cover of the Wireless Bridge.

2. Con

nect the DC cable’s ground wire to V- terminal. If you are looking at the terminal

block with the wiring terminal screws on top, the V- terminal is on the left side.

3. Con

nect the DC cable’s +12V DC wire to the V+ terminal. If you are looking at the

terminal block with the wiring terminal screws on top, the V+ terminal is on the right

side.