User Manual

28
Pre-Installation Configuration
Access the Web Interface
Figure 20. Enable SNMP Access Control List
To restrict SNMP access to the Wireless Bridge:
1. On t
he Administration > Management page, click on SNMP Only under the heading
“TR069 / SNMP Management Choice.”
2. Sele
ct Enabled next to the “SNMP ACL” line.
3. Enter the IP addr
esses of up to 4 SNMP servers.
4. Click Update Settings to confirm
changes.
For Flexmaster server management, refer to
“(Optional) Set the FlexMaster Server
Address” on page 60.
Step 7: Change Non-Root Bridge Configuration Settings
Repeat steps 1-6 for the Non-Root bridge for any changes you made to the Root bridge
settings. If you did not make any changes, you only need to repeat step 1 to provide power
and Ethernet to the non-root bridge, then proceed to
Step 8: Test the Link Between the
Bridges. Note that setting the Country Code for the Root Bridge requires that the same
setting be made for the Non-Root Bridge.
Step 8: Test the Link Between the Bridges
The SpeedFlex utility lets you test the data transfer speeds between the two bridge units.
Click the SpeedFlex icon
on the home page (Status > Wireless) to begin testing.