User Manual

22
Pre-Installation Configuration
Access the Web Interface
Figure 14. Reboot the wireless bridge to apply country code change
7. When the reboot is completed, log in again to continue making configuration changes.
CAUTION: Do not change the Channel setting until after the Country Code has been set
for both units.
8. You have completed setting the Country Code. Continue to “Step 6: Change Optional
Configuration Settings”.
Step 6: Change Optional Configuration Settings
This section describes optional configuration settings that you can change prior to
beginning the physical installation. These settings include:
■ IP address
■ Device name and location
■ SSID, encryption method and passphrase
■ Management VLAN
■ Network management method
NOTE: Ruckus Wireless recommends leaving these settings at their default values until
installation of both bridge units is complete. Not
e that any changes made to the root
bridge settings must also be performed on the non-root bridge.