User Manual

17
Pre-Installation Configuration
Access the Web Interface
NOTE: Make sure that you configure the Local Area Connection properties, not the
Wireless Network Connection properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties. The Internet
Protocol (TCP/IP) Properties dialog box appears.
4. Write down all of the currently active network settings. You will need this information
later when you restore your computer to its current network configuration.
5. Click Use the
following IP address, and then configure the IP address settings with
the values listed in Table 5. For a sample configuration, refer to Figure 9.
Table 5. Configure your computer’s IP address settings
IP address 192.168.2.22
(or any address in the 192.168.2.x
network—with the exception of 192.168.2.1 and
192.168.2.254 which will be used by the bridges)
Subnet mask 255.255.255.0
Default gateway 192.168.2.1
Preferred DNS server 192.168.2.1
You can leave the Alternate DNS
server box blank.
6. Click OK to save
your changes and close the TCP/IP Properties dialog box.
7. Click OK a
gain to close the Local Area Connection Properties dialog box.
Windows saves the IP address settin
gs that you have configured.