User Manual

15
Pre-Installation Configuration
Access the Web Interface
2. Connect the DC cable’s ground wire to V- terminal. If you are looking at the terminal
block with the wiring terminal screws on top, the V- terminal is on the left side.
3. Con
nect the DC cable’s +12v DC wire to the V+ terminal. If you are looking at the
terminal block with the wiring terminal screws on top, the V+ terminal is on the right
side.
Figure 7. Connect the ground wire to the V- terminal and the +12v DC wire to the V+
termi
nal
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal
4. Using a 3mm Phillips screw, tighten the wiring terminal screws. Screw torque value must
be 20.5 mN-m ± 2 mN-m.
5. Connect the DC term
inal block to the 12V DC port on the Wireless Bridge.