User Manual

47
Physical Installation
Attaching the Mounting Brackets
Figure 40. Mark the locations of the mounting holes
3. Remove the static bracket from the mounting surface.
4. Drill a
n 8mm-diameter hole with a depth of 36mm-38mm into each of the markings
that you made on the mounting surface.
5. Insert a wall a
nchor (with the unthreaded part first) into each of the holes that you
drilled.
6. Place a
metal cone on each wall anchor, and then place a flat washer on top of the
metal cone.
Figure 41. Insert a wall anchor into each hole that
you drilled, and then place a metal
cone and a flat washer on top