User Manual

Physical Installation

Deploying the Wireless Bridge

Step 2: Install the Back Panel Cover

1. Make sure that the perimeter rubber gasket on the underside of the bottom cover is

in place and is clear of debris.

2. Place the bottom cove

r of the Wireless Bridge onto the bottom section.

3. Using the

three gasketed machine screws that are supplied with the Wireless Bridge,

fasten the bottom cover to the chassis. Screw torque value must be 6.9 ± 0.2 kgf-cm

(6.2 ± 0.2 lbfin) to obtain a proper seal.

Figure 38. Fasten the bottom cover using three machine screws

Step 3: Connect the Wireless Bridge to the Network

In this step, you will connect the Wireless Bridge from its mounting location to the

network. Follow the steps below for a typical installation that uses both PoE and DC

power as power sources.

Figure 39 shows an example of the connections required for a

typical installation that uses both PoE and DC power.