User Manual

55
Physical Installation
Mounting the Wireless Bridge
Figure 51. Insert thumb screws into the upper mounting holes
7. Finger tighten the thumb screws.
8. Adjust the W
ireless Bridge to your desired orientation.
NOTE: If you have not yet determined the optimal orientation for your Wireless Bridge,
refer to
“Determine the Optimal Mounting Location and Orientation” on page 36 for
orientation guidelines.
9. Using a 10mm ratchet wrench, tighten the hex bolts to fix the Wireless Bridge’s
orientation. Screw torque value must be 0.7 N-m ± 0.1 N-m.
You have completed mounting the root bridge. Perform the same procedure for mounting
the non-root bridge.