User Manual

52
Physical Installation
Mounting the Wireless Bridge
3. Using a 6mm Phillips screwdriver, tighten the four machine screws to fasten the bracket
to the Wireless Bridge. Screw torque value must be 0.4 N-m ± 0.1 N-m.
Figure 48. Fasten bracket to the Wireless Bridge
4. Continue to “Mounting the Wireless Bridge” in the next section.
Mounting the Wireless Bridge
To mount the Wireless Bridge, you will need to join the two mounting brackets that you
attached earlier to the device and the mounting surface. For this procedure, you will need
the following items:
■ Hex bolts
■ Thumb screws
■ 10mm ratchet wrench
NOTE: Figures in this section show mounting on a vertical pole. Procedures for mounting
on a flat surface are similar.
To join the two mounting brackets together:
1. Join the two brackets as shown in Figure 49. Make sure that: