User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
52
Physical Installation
Mounting the Wireless Bridge
3. Using a 6mm Phillips screwdriver, tighten the four machine screws to fasten the bracket
to the Wireless Bridge. Screw torque value must be 0.4 N-m ± 0.1 N-m.
Figure 48. Fasten bracket to the Wireless Bridge
4. Continue to “Mounting the Wireless Bridge” in the next section.
Mounting the Wireless Bridge
To mount the Wireless Bridge, you will need to join the two mounting brackets that you
attached earlier to the device and the mounting surface. For this procedure, you will need
the following items:
■ Hex bolts
■ Thumb screws
■ 10mm ratchet wrench
NOTE: Figures in this section show mounting on a vertical pole. Procedures for mounting
on a flat surface are similar.
To join the two mounting brackets together:
1. Join the two brackets as shown in Figure 49. Make sure that: