User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
40
Physical Installation
Deploying the Wireless Bridge
Figure 32. Connect the Ethernet cables and power adapter to the PoE injector
To N etworkTo Outdoor Bridge
To AC Power Source
7. Take out one of the 20mm x 30mm sealing strips from the accessories bag.
8. Remove the
adhesive backing from the sealing strip.
9. W
rap the sealing strip around the Ethernet cable, about 60mm from the Ethernet
connector.
Figure 33. Wrap the sealing strip around th
e Ethernet cable, 60mm from the Ethernet
connector
60mm
Sealing strip
10. Place the Ethernet cable in the cavity on the enclosure, and then press it into position.
Make sure the sealing strip protrudes beyond the entry and exit points.
11. W
rap the white P-clip cable clamp around the Ethernet cable, and then fasten it to the
Wireless Bridge chassis using one of the short machine screws supplied.