User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
34
Provisioning and Associating the Wireless Bridge Pair (Optional)
Associating
8. Repeat steps 2-7 for the non-root bridge, selecting Non-Root Bridge on Step 3, and
making sure you enter the same values on the WLAN Configuration page as those of
the root bridge.
You have finished manually provisioning the wireless bridge pair.
Associating
Once the bridge pair has been provisioned, verify that they have associated with one
another. If no association between the two bridge units has been established, the following
will be displayed:
Figure 27. No association established
The units will automatically associate with one another after about 1 to 2 minutes. Once
the association is complete, the page will refresh and the Connected Device information
will be displayed, as shown: