User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
33
Provisioning and Associating the Wireless Bridge Pair (Optional)
Manual Provisioning Using the Web Interface
3. Select Root Bridge and click Next to continue.
4. A
djust settings on the WLAN configuration page if necessary, and click Next to
continue.
Figure 25. WLAN Configuration options
5. Set the Country Code to your location. Do not change any of the settings under
Channel, Channel Width, or Broadcast SSID at this time.
6. W
rite down the SSID, encryption settings and Passphrase, as you will need to enter
these values when you provision the Non-Root bridge.
Figure 26. Reboot after completing th
e Provisioning Wizard
7. Click Reboot to confirm changes and reboot the bridge.