User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
28
Pre-Installation Configuration
Access the Web Interface
Figure 20. Enable SNMP Access Control List
To restrict SNMP access to the Wireless Bridge:
1. On t
he Administration > Management page, click on SNMP Only under the heading
“TR069 / SNMP Management Choice.”
2. Sele
ct Enabled next to the “SNMP ACL” line.
3. Enter the IP addr
esses of up to 4 SNMP servers.
4. Click Update Settings to confirm
changes.
For Flexmaster server management, refer to
“(Optional) Set the FlexMaster Server
Address” on page 60.
Step 7: Change Non-Root Bridge Configuration Settings
Repeat steps 1-6 for the Non-Root bridge for any changes you made to the Root bridge
settings. If you did not make any changes, you only need to repeat step 1 to provide power
and Ethernet to the non-root bridge, then proceed to
Step 8: Test the Link Between the
Bridges. Note that setting the Country Code for the Root Bridge requires that the same
setting be made for the Non-Root Bridge.
Step 8: Test the Link Between the Bridges
The SpeedFlex utility lets you test the data transfer speeds between the two bridge units.
Click the SpeedFlex icon
on the home page (Status > Wireless) to begin testing.