User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
22
Pre-Installation Configuration
Access the Web Interface
Figure 14. Reboot the wireless bridge to apply country code change
7. When the reboot is completed, log in again to continue making configuration changes.
CAUTION: Do not change the Channel setting until after the Country Code has been set
for both units.
8. You have completed setting the Country Code. Continue to “Step 6: Change Optional
Configuration Settings”.
Step 6: Change Optional Configuration Settings
This section describes optional configuration settings that you can change prior to
beginning the physical installation. These settings include:
■ IP address
■ Device name and location
■ SSID, encryption method and passphrase
■ Management VLAN
■ Network management method
NOTE: Ruckus Wireless recommends leaving these settings at their default values until
installation of both bridge units is complete. Not
e that any changes made to the root
bridge settings must also be performed on the non-root bridge.