User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Wireless Bridge
- 3 Before You Begin
- 4 Pre-Installation Configuration
- Summary of Pre-Installation Tasks
- What You Will Need
- Access the Web Interface
- Step 1: Connect the Power and Ethernet Cables
- Step 2: Prepare the Administrative Computer
- Step 3: Connect the Wireless Bridge to the Admin Computer
- Step 4: Log In to the Web Interface
- Step 5: Change the Country Code
- Step 6: Change Optional Configuration Settings
- Step 7: Change Non-Root Bridge Configuration Settings
- Step 8: Test the Link Between the Bridges
- Step 9: Disconnect the Wireless Bridge from the Administrative Computer
- Step 10: Restore the Administrative Computer’s Network Settings
- 5 Provisioning and Associating the Wireless Bridge Pair (Optional)
- 6 Physical Installation
- Prepare the Required Hardware and Tools
- Determine the Optimal Mounting Location and Orientation
- Become Familiar with the Installation Components
- Decide How You Will Supply Power to the Wireless Bridge
- Deploying the Wireless Bridge
- Attaching the Mounting Brackets
- Mounting the Wireless Bridge
- Mounting and Connecting the External Antenna (Optional)
- 7 Aiming the Bridge Pair
- 8 Verifying the Connection
- 9 What to Do Next
20
Pre-Installation Configuration
Access the Web Interface
Figure 11. Ruckus ZoneFlex 7731 Wireless Bridge Status :: Wireless page
8. Continue to “Step 5: Change the Country Code”.
Step 5: Change the Country Code
Change the Country Code setting to your location and reboot the bridge for updates to
take effect.
CAUTION: If changing the Country Code after the pair has been mounted, you will need
to configure the remote unit first followed by the local unit, to avoid loss of connectivity.
NOTE: If you purchased the Wireless Bridge in the United States, this value is fixed to
“United States” at the factory and is not user configurable.
If you purchased the Wireless Bridge outside of the United States, verify that the value is
set to your country or region. Selecting the correct country code ensures that the Wireless
Bridge uses only the radio channels allowed in your country or region.
1. On the Configuration > Wireless page, select your location from the Country Code
menu.
2. The f
ollowing warning message appears: