User Manual

14
Pre-Installation Configuration
Access the Web Interface
NOTE: You only need to connect one type of power source at this point, even if you are
planning to use both PoE and DC power in your
final deployment.
Use Power Over Ethernet
1. Take out the PoE injector and the power adapter from the Wireless Bridge package.
2. Obtain two Ethernet cables.
3. Connect one
end of one Ethernet cable to the AP/BRIDGE port on the PoE injector,
and then connect the other end to the RJ45 port on the ZoneFlex 7731.
4. Con
nect one end of the other Ethernet cable to the NETWORK port on the PoE
injector.
5. Con
nect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter into a power source. The single LED on the PoE injector turns
green.
6. Check the power LED
on the ZoneFlex 7731 to ensure power is being supplied to the
bridge.
Figure 6. Connect the Ethernet cables and p
ower adapter to the PoE injector
To Adm in
Computer
To Bridge
To AC P ow er Source
You have completed connecting the Wireless Bridge to a PoE power source.
Use DC Power
To use DC to power the Wireless Bridge, you need to connect a DC cable (not supplied
with the Wireless Bridge) to the DC terminal block.
1. T
ake out the DC terminal block from the small plastic bag that contains the bottom
cover of the Wireless Bridge.