User's Manual

ESR600H/ESR750H
6-87
USER GUIDE
ADVANCED NETWORK SETTINGS
ROUTING SETUP
NAT Enabled
If the router is connected with a network under the different
subnet, the routing setup allows the network connection
within two different subnets.
 Enable Static Routing Click Enable Static Rout-
ing to activate the feature.
 Destination LAN IP Enter the LAN IP address of the
destination device.
 Subnet Mask Enter the Subnet Mask of the destination
device.
 Default Gateway Enter the default gateway IP address
for the destination device.
 Hops Enter the maximum number of hops within the
static routing that a packet is allowed to travel.
Click Add to save the settings and list the configuration in the
Current Static Routing table or Reset the discard changes.
Click Apply to save the settings or Cancel to discard
changes.