CR3000 XP 300N Wi-Fi Router with Dragon88™ Firmware and CloudCommand™ XP Service Quick Install Guide
STEP 1: Preparation Unit Identification Code (UIC) label As you start the setup process, take your router out of the box, unwrap it and look at its bottom surface. Then identify the yellow label as in the figure below, and take note of its Unit Identification Code (UIC).
Power adapter assembly The CR3000 includes a power adapter designed to operate in multiple regions. Please select the power plug corresponding to your region and fully slide it in the body of the adapter until it securely snaps into place. Please operarate the CR3000 exclusively with the included adapter. Utilizing a different adapter may result in malfunction and permanent damage, voiding all warranties. INPUT: 100 – 240 VAC at 50/60 Hz, 0.
Step 2: Setup and First Configuration Option 1: You have active Internet access and your modem provides automatic DHCP service 1. While connected to the Internet using your old router, visit http://enable.cloudcommandxp.com. 2. Create an account or login with your Google credentials and follow the setup wizard. 3. Once the setup wizard is complete, disconnect your old router from your DSL/CABLE modem or the network port with access to the Internet you are intending to connect the CR3000 Router to. 4.
Option 2: Your Internet modem does NOT provide automatic DHCP service or you are not sure if it does 1. If you are already using a router, disconnect it from your DSL/CABLE modem or from the network port with access to the Internet you are intending to connect the CR3000 Router to. 2. If using a DSL/CABLE modem, restart it now by power-cycling it. 3.
8. If your router does not auto-detect an Internet connection, you will be presented with a screen asking for basic configuration information as required by your Internet Service Provider, as shown in Figure 3. 9. After this step, or if your router does auto-detect an Internet connection, you will be automatically directed to create an account for the Cloud service and subsequently to a wizard that will guide you to configure your network in a few easy steps. 10.
Troubleshooting Connectivity. If after following the setup steps you are not redirected automatically to the CR3000 Cloud service portal, ensure the cable inserted into the INTERNET port on the back of the Router is properly connected and all connectors are clicked into place. Misconfiguration. If you are unsuccessful completing the setup and believe your Router is misconfigured or otherwise stuck in an unresponsive state, you can factory reset it.
Wi-Fi Performance Optimization Positioning Position your router on a flat surface as unobstructed as possible, at least 3 ft (1m) from large metallic surfaces and at least 3 ft (1m) from the floor. Do not place it inside a small closet or cabinet.
Channel Choice Detect the clearest channel available by determining what other devices are broadcasting on each channel avaialble to your router. To do so you can install on your computer a free Wi-Fi scanning tool such as: - inSSIDer (http://www.metageek.net/products/inssider) - NetSpot (http://www.netspotapp.com). After determining which is the least utilized channel in your area, select it for your router. You can learn more about Wi-Fi channels at http://en.wikipedia.
CloudCommand XP Dashboard 10
Connectors and LEDs Local Area Network 5V DC Power Internet Connection Reset Button Power On & CloudCommand Connection Internet Wi-Fi On/Off 11 LAN Activity
Technical Support Support is available through your Enable Networks Authorized Resellers. Website http://www.enablenetworks.com Support Email enable.support@enablenetworks.com Copyright ©2013 PowerCloud Systems, Inc. All rights reserved. PowerCloud™ and CloudCommand™ are trademarks of PowerCloud™ Systems, Inc. All rights reserved. Other trademarks are the property of their respective owners.