User Manual

WL-343v2 001 IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.2
34
 Status: This indicates the state of the client. There are three options:
o Associated: Indicates that the wireless client is connected to an
Access Point (AP). The BSSID is shown in the form of 12 HEX
digits, which is the MAC address of the AP.
o Scanning: Indicates that the wireless client is searching for an AP
in the area.
o Disconnected: Indicates that there are no APs or clients in the
area.
 Current Channel: The operating frequency channel that the client is
using (infrastructure mode).
 Link Speed: The current rate at which the client is transmitting and
receiving.
 Throughput (bytes/sec): Displays the Tx (transmit) and Rx (receive)
kilo-bytes per second.
 Link Quality: This bar displays the transmission quality between an AP
and a client.
 Signal Strength: This bar displays the strength of the signal received
from an AP or client.
 Noise Level: Displays the background noise level; a lower level
indicates less interference.
 HT: High Through-Put / 802.11 n Section
 BW: Channel Bandwidth
 GI: Guard Interval
 MCS: Modulation Coding Scheme
 Click on the OK button to close this window.
 dBm Check Box. When you click on the check box as the drawing
below. The signal strength and noise level will be shown as the dBm
measurements.