User Manual Part 1

4.1.2. PPPoE (Point-to-Point Protocol over Ethernet)

 The WAN interface can be configured as PPPoE. This type of connection is usually used for a DSL service and requires a

username and password to connect.

 Address Mode: PPPoE can be used with a dynamic or static IP address. If you select the Dynamic IP radio button, then the IIP

address in the next field is not required. However, if you select the Static IP radio button, then the IP address in the next field is

required.

 IP Address: Specify the IP address if the Static IP is selected.

 User Name: Specify the username which is provided by your ISP.

 Password: Specify the password which is provided by your ISP, and then verify it once again in the next field.

 Verify Password: Enter the password again for verification

 Service Name: Specify the name of the ISP. This is optional.

 Reconnect Mode:

o Keep Connection: This option provides a continuous connection.