User Manual

101
10.8. Routing
If your wireless router is connected to a network with
different subnets, this feature will allow the different
subnets to communicate with each other.
Note: The NAT function needs to be disabled for the
Routing feature to be enabled.
Static Routing
Enable Static Routing
Check this box to enable the Static Router feature.
Destination LAN IP
Enter the IP address of the destination LAN.
Subnet Mask
Enter the Subnet Mask of the destination LAN IP address
Default Gateway
Enter the IP address of the Default Gateway for this destination IP and Subnet.
Hops
Specify the maximum number of Hops in the static routing rule.
Interface
Select whether the routing applies to LAN or WAN interfaces.