User's Manual

~
31
~
soft key) to answer.
4.
During the call, press the key, the speakerphone is active.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset
menu), the SILENT key operation is valid only for the current
call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked
by the caller or the originating phone company.
Receiving an Intercom Call
1.
When an intercom call arrives, the ringer will ring or vibrate unless the ringer
has been turned off. Press to answer the intercom call.
2.
If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and press the key
to start conversation.
3.
If the handset is not on the cradle, press any key (except , and the SILENT
soft key) to answer.
4.
During the call, press the key, the speakerphone is active.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer the SILENT key operation is
valid only for the current call.
Ending a Call
To end a telephone or intercom call, press key or place handset into charger
cradle.
~
32
~
Adjusting Receiver (Earpiece) Voice Volume
1.
Voice volume can only be adjusted during a call.
2.
There are 6 levels of volume selections. Default =
1
.
Use
or arrow key to adjust
3. The new setting remains effective for all future calls
until changed.
Placing a Call On Hold
1.
When a call is in progress, it can be put on hold by
pressing the HOLD (Right) soft key or the key.
2.
To return to the conversation, p
ress
U
NHOLD
Notes:
1. The call being placed on hold can only be “un-hold” by the
handset that puts it on hold.
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
4. You can power off the handset (e.g., change battery) while call
is on hold. After power on again, you can continue the call by
pressing UNHOLD (Left) soft key or select “4” from the Option
(only for 1X) menu to terminate the hold state.
Mute
1.
After a link is established, you can press
OPTION
(Left) soft key and
press “0” to mute the handset microphone
.
2.
When mute is active, the other end wi
ll not hear your voice, but still can speak
to you.



11

00:00:10
Volume:4
MUTE HOLD



11

You have a
Call on hold
UNHOLD
OPTION