User's Manual

~
29
~
intercom call from a handset.
Making a Broadcast
A. Handset to Handset Calls
1.
Broadcasting all handsets
a.
Press and hold key from one handset.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
.
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
.
d.
Release the key and return to IDLE mode.
2.
Broadcasting a group of handsets
a.
Enter the Group ID then press and hold key.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
.
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination hand
sets will be opened up
.
d.
Release the key and return to IDLE mode.
3.
Broadcasting an individual handset
a.
Enter the Handset ID then press and hold key.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
.
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
.
d.
Release the key and return to IDLE mode.
B. Broadcasting from Base to Handset (Register to 1X base only)
1.
Broadcast to all handsets
a.
Press key on the base station to intercom all
registered handsets.

11

PA paging
to all…

11

PA paging
to Ext. # 02

11

PA paging
to Ext. # 12



11

PA paging from
Base 1
SILENT
~
30
~
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c.
The Broadc
ast LED will light up
.
d.
Press the key again and return to IDLE mode.
C. Broadcasting from Handset to Base (Register to 1X base only)
1.
Broadcast to the base station
a.
Enter the Base ID then press and hold key.
b. Hear bi-bi-beep while the initiating handset
broadcast the base stations.
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
the base will be opened up
.
d.
Release the key and return to IDLE mode.
Redial
1.
Press
REDIAL
(Left) soft key.
2.
The LCD shows the last phone number dialed. To dial this number, press
DIAL
(Left) soft key.
3.
Use or Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press DIAL soft key.
[Note
]
Intercom numbers (Handset ID) are not stored in the last 10 numbers
dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate unless the ringer
has been turned off.
2.
If the handset is on the charge
r cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and press the to
start conversation.
3.
If the handset is not on the cradle, press any key (except , and the Silent

11

PA paging
to Ext. # 10