User's Manual

~
27
~
Making a Telephone Call
1.
Press , wait for dial tone, and then enter phone number.
2.
Alternatively, you can enter phone number first then press key.
When using this method, you can use the CLEAR (Left) and DELETE (Right) soft
keys to edit the number entered. “Delete” erases the last digit entered.
“Clear” erases the entire line but remains in the dialing mode.
3.
Speed dial
by acce
ss the entries in the phone book
a. Press or scrolling key to enter the phone
book
b.
Press to dial out the number
4.
To abort dialing, press key.
5.
During the call, press the key to activate the
speakerphone.
Notes:
1. After a link established, the Base ID will appear on the upper-right
corner. If no Base ID shown up, it applied that you are approaching
the boundary of the coverage.
2. If the line is occupied, the LCD shows “No Line Available” and handset
returns to standby mode.
3. If a link cannot be established, the LCD will show “No Base” after a 12-
second time out.
4. A call duration timer will start displaying the length of the call after
link is established.
Making an 2-Way/ Intercom Call
The EnGenius Industrial Cordless Phone System offers private, Intercom/ 2-way
radio calls independence of base station. Intercom/ 2-way communication can be
placed from or to base stations and handsets.



11

EnGenius
8884328668
ADD
OPTION
~
28
~
A. Handset to Handset Calls
1.
Press key followed by a two-digit handset ID or
Group ID.
2.
Press key to end the call.
3.
During the call, press the key, the speakerphone
is active.
Notes:
1. Intercom calls can be made regardless if the Base Station is
present.
2. If a Group ID is entered, the first handset (belonging to
that group) that answers will establish a link with the
caller. See Handset Group Subscription.
3. If a link cannot be established, the LCD shows “No
Connection” after a 12-second time out.
B. Intercom/2-Way from Base to Handset (Register to 1X base only)
1.
Press key on the base station to intercom all
registered handsets. The first handset to answer will
establish a voice link with the base.
2.
The INTERCOM LED will flash until a handset responds.
3. The base unit will page for 15 seconds, then terminate the page if no handset
responds.
4.
Before a handset answers, the INTERCOM can be cancelled from the base by
pressing again. However, once a handset answers, only the answering
handset can end the call.
C. Intercom/2-Way from Handset to Base (Register to 1X base only)
1.
Press key followed by a two-digit base ID
[Note: Base 1 ID as 10, Base 2 ID as 20, Base 3 ID as 30,
and Base 4 ID as 40]
2.
The base will ring once, then automatically conne
ct the

11

Please enter
Ext. #: 12



11

Intercom from
Base 1
SILENT

11

Please enter
Ext. #: 10