User's Manual

~
23
~
Getting Started
Handset and Charger Installation
1. Plug the transformer end of the Charger AC/DC adaptor into a standard AC
electric power outlet, plug the other end into the “DC In” jack on the back of
the Charger.
2.
Install battery pack onto the handset.
3.
Install handset antenna.
4.
Place handset onto the charg
ing
slot.
5.
Fully charge the battery for three hours before us
e.
6. The phone system is now ready to perform basic functions such as making and
receiving phone calls and intercom calls. No base station or handset
programming is needed for basic operations.
Note:
1. Handset(s) packaged along with a Base Station are pre-
registered at the factory. If you have a new handset, you will
need to register the handset with the base station in order to
be recognized as a member handset by the base(s) and by
other handsets. See Handset Registration.
2. Fully charge battery packs before the first usage.
~
24
~
Basic Operations
Operation Modes
Both the base station and handset have levels of operation at which time only
certain procedures of functions can be performed.
A. Base Operation Modes
1. IDLE mode (Register to 1X base only) - this is the default mode. The intercom,
broadcast, and volume keys are active in IDLE mode.
2. TALK mode (Register to 1X base only) - the base operates in this mode during
phone call, intercom, and broadcast operation. The “In Use”, “Intercom”, and
“Broadcast” LED will light up respectively.
3. REGISTRATION mode- the base enters this mode by pressing the REG button
for three seconds. There are no active base unit keys once this mode has been
entered. Four LEDs will be lighted up in R
egi
stration mode.
B. Handset Operation Modes
1.
IDLE mode
-
this is the default mode.
a. If there is no on-going activity, the handset
automatically goes into SLEEP/IDLE mode to save
battery power.
b.
The handset can be turned off completely by
holding down the key for 3 seconds.
c. The idle screen display (custom name) can be
edited.
d.
The 2
-
dight number represents the handset ID
2.
Menu
mode
a. Press the Right soft function key to activate MENU
mode.
b. In MENU mode, the handset settings and
information contained in memory can be changed.
c. The functions available through the MENU selection
are covered in
greater
detail from page
67
.
d.
The MENU structure display as below:



11

Welcome!
REDIAL MENU



11

Main Menu: 
1.KeyGuard
2.PhoneBook