802.
PRODUCT DESCRIPTION The PCE4551AH is a 5H dual band concurrent 3T3R PCIe module base On QCA9890 solution. PRODUCT SPECIFICATION RF Specification Radio 1 Interface Operating Voltage Antenna Connectors Frequency Band Date Rate Receive Sensitivity (Typical) Support 5GHz 64-bit PCI-E 3.3V I-PEX 802.11 a/n/ac 5150-5850MHz 1300Mbps 802.11a 802.11a/n_HT20 802.11n_HT40 802.
Type Connector 5150-5250MHz 5250-5350MHz 5470-5725MHz 5725-5850MHz Dipole UFL 3dBi 3dBi 3dBi 3dBi Dipole UFL 5.5dBi 5.5dBi 5.5dBi 5.5dBi PIFA UFL 6dBi 6dBi 6dBi 6dBi Note: The EUT has three antennas. (3TX/3RX) Any change or modifications not expressly approved by the manufacture could void the user’s authority to operate this equipment.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
Industry Canada Equipment Standard for Digital Equipment (ICES) – Canada CAN ICES-3 (B) / NMB-3 (B) This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
End Product Labeling, Labeling Requirements for the Host device The host device shall be properly labelled to identify the modules within the host device.
