User's Manual

-
10 -
About
This page displays the information of the WLAN Module Version.
Switch to AP Mode
To access the soft AP mode, please select the Mode on the function list of the Utility to make the
WLAN Module act as a wireless AP.
Soft AP mode
General
General
SSID
Shows the network name of the AP.
BSSID
Shows the MAC address of the AP.
Association Table
This table shows the connected client here.
Config
Click the Config button to set up the Wireless Network Properties.
Network Name (SSID): User can change the network name of this access
point.
Channel: User can select the channel form the pull-down list.
Wireless network security
Network Authentication: There are several types of authentication
modes including Open System, Shared Key, WPA-PSK and WPA2-PSK.
Data encryption: For Open System and Shared Key authentication mode,
the selection of encryption type is WEP. For WPA-PSK, WPA2-PSK,
authentication mode, the encryption type supports both TKIP and AES.
When encryption is set to WEP…
ASCII: Only valid when using WEP encryption algorithm. When key
length is set to 64 bits user can enter 5 ASCII characters (case sensitive),
and 128 bits for 13 ASCII characters (case sensitive).
PASS PHRASE: Only valid when using WEP encryption algorithm.
When key length is set to 64 bits user can enter 10 Hexadecimal characters
(0~9, a~f) and 128 bits for 26 Hexadecimal characters (0~9, a~f).