User Manual

2 Understanding the Hardware
2.1 Hardware Installation
1 Place the unit in an appropriate location after conducting a site
survey.
2 Plug one end of the Ethernet cable into the Network port of the PoE
injector and another end into your PC/Notebook.
3 Plug one end of another Ethernet cable to AP/Bridge port of the PoE
injector and the other end into you cable/DSL modem (Internet)
4 Insert the DC-inlet of the power adapter into the 24V port of the PoE
injector and the other end into the power socket on the wall.
This diagram depicts the hardware configuration
2.2 Hardware Description
The images below depict the front and rear panel of the Access Point /
Client Bridge.
PoE Injector
PC,
Cable/DSL
Modem
Power
Ethernet
AC/DC
cable
Ethernet
Access
Front Panel Rear Panel