User Manual

Long Range Wireless Access Point / Client Bridge Version 1.0
62
6.6.4 Firmware Upgrade
 Click on the Upgrade Firmware link under the Management menu.
This page is used to upgrade the firmware on the device. Make sure
that downloaded the appropriate firmware from your vendor.
 Click on the Browse button and then select the appropriate
firmware and then click on the Upgrade button.
Note: The upgrade process may take about 1 minute to complete.
Do not power off the device during this process as it may crash the
device and make it unusable. The device will restart automatically
once the upgrade is complete.
6.6.5 Time Settings
 Click on the Time Settings link under the Management menu. This
page allows you to configure the time on the device. You may do
this manually or by connecting to a NTP server.
 Manually Set Date and Time: Specify the date and time
 Automatically Get Date and Time: Select the time zone from the
drop down list and then specify the IP address of the NTP server.
 Click on the Apply button to save the changes.