User Manual

Long Range Wireless Access Point / Client Bridge Version 1.0

 Remote Management: Choose to enable or disable remote

management.

 Remote Upgrade: Choose to enable or disable remote firmware

upgrade.

 Remote Management Port: Specify a port for remote management.

For example, if you specify 8080, then you will need to specify <IP

address>:<port> 192.168.1.1:8080 to connect to the web interface

of the device.

 Click on the Apply button to save the changes.

6.6.2 SNMP Settings

 Click on the SNMP Settings link under the Management menu. This

option allows you to assign the contact details, location, and

community name and trap settings for SNMP. This is a networking

management protocol used to monitor network-attached devices.

SNMP allows messages (called protocol data units) to be sent to

various parts of a network. Upon receiving these messages, SNMP-

compatible devices (called agents) return data stored in their

Management Information Bases. .

 SNMP Enable/Disable: Choose to enable or disable the SNMP

feature.

 Contact: Specify the contact details of the device.

 Location: Specify the location of the device.

 Read-Only Community Name: Specify the password for access the

SNMP community for read only access.

 Read-Write Community Name: Specify the password for access to

the SNMP community with read/write access.

 Send SNMP Trap: Specify the IP address of the computer that will

receive the SNMP traps.