User Manual

Long Range Wireless Access Point / Client Bridge Version 1.0
57
 Authentication Type: Select an authentication method. Options
available are Open Key, Shared Key or Auto. An open system allows
any client to authenticate as long as it conforms to any MAC
address filter policies that may have been set. All authentication
packets are transmitted without encryption. Shared Key sends an
unencrypted challenge text string to any device attempting to
communicate with the Access Point. The device requesting
authentication encrypts the challenge text and sends it back to the
Access Point. If the challenge text is encrypted correctly, the
Access Point allows the requesting device to authenticate. It is
recommended to select Auto if you are not sure which
authentication type is used.
 Input Type: Select He or ASCII from the drop-down list
 Key Length: Select a key format from the drop-down list. 64bit-hex
keys require 10 characters, where as 128-bit keys require 26
characters. A hex key is defined as a number between 0 through 9
and letter between A through F.
 Default Key: You may use up to four different keys for four different
networks. Select the current key that will be used.
 Key 1-4: You may enter four different WEP keys.
 Click on the Apply button to save the changes.
6.5.2.2 Wireless Security – WPA-PSK, WPA2-PSK
 Security Mode: Select WPA-PSK, or WPA2-PSK from the drop-down
list if your wireless network uses WPA pre-shared key.
 Encryption: Select TKIP or AES from the drop-down list if your wireless
network uses this encryption. WPA (Wi-Fi Protected Access) was
designed to improve upon the security features of WEP (Wired
Equivalent Privacy). The technology is designed to work with existing
Wi-Fi products that have been enabled with WEP. WPA provides
improved data encryption through the Temporal Integrity Protocol