User Manual

Long Range Wireless Access Point / Client Bridge Version 1.0
17
 Operating Mode: Select and operating mode. Configuration for
each operating mode is described in their respective chapters.
 Click on the Apply button to save the changes.
4.3.2 IP Settings
 Click on the IP Settings link under the System drop-down menu This
page allows you to configure the device with a static IP address or
a DHCP client.
 IP Network Setting: Select Obtain an IP address automatically (DHCP)
radio button if the Access Point is connected to a DHCP server. This
will allow the Access Point to pass IP addresses to the clients
associated with it. You may select Specify an IP Address radio
button if you would like the device to use a static IP address. In this
case, you would be required to specify an IP address, subnet mask,
and default gateway IP address.
 IP Address: Specify an IP address
 IP Subnet Mask: Specify the subnet mask for the IP address
 Default Gateway: Specify the IP address of the default gateway.
 Click on the Apply button to save the changes.
4.3.3 Spanning Tree Settings
 Click on the Spanning Tree link under the System drop-down menu
Spanning-Tree Protocol is a link management protocol that provides
path redundancy while preventing undesirable loops in the network.