User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
50
Professional Installation Instructions
Personal Installation
11 Professional Installation Instructions
Personal Installation
This product is designed for specific application and needs to be installed by a qualified
personal who has RF and related rule knowledge. The general user shall not attempt to
install or change the setting.
Installation Location
The product shall be installed at a location where the radiating antenna can be kept 20
cm from nearby person in normal operation condition to meet regulatory RF exposure
requirement.
External Entenna
Use only the antennas which have been approved by Ruckus Wireless. The non-approved
antenna(s) may produce unwanted spurious or excessive RF transmitting power which may
lead to the violation of FCC limit and is prohibited.
Installation Procedures
Please refer to user’s manual for the detail.
Warning
Please carefully select the installation position and make sure that the final output power
does not exceed the limit set force in US Rule CFR 47 part 15 section 15.247 & 15.407. The
violation of the rule could lead to serious federal penalty.